When I go in to TERM and power the unit on. A little square appears by the cursor.
I can access the NADSbox, as I have a REX and thus TR-DOS already installed. I was able to access the NADSbox by selecting DISK in TR-DOS. On Mon, 6 Jan 2020, 5:12 pm Ken Pettit, <[email protected]> wrote: > Hi James, > > I you go into TERM first and then power on the NADSBox, do you get a > prompt stating you need to activate? I wouldn't expect the activation mode > to ever respond with "unkown command" or even "UNKNOWN COMMAND". Try just > hitting enter ... perhaps on your unit I simply forgot to put the NADSBox > into activation mode. > > Ken > > On 1/6/20 7:33 AM, James Zeun wrote: > > I thought that, but when I turn echo off it doesn't seem to work. Will try > it again. > > Also w > When I turn the unit on, It doesn't post and text. Which the manual says > it should > > On Mon, 6 Jan 2020, 3:02 pm Kurt McCullum, <[email protected]> wrote: > >> Sounds like you have the local echo on which echoes every key you type >> and then the NADSBox is also echoing everything in term mode, which is >> normal. I am not in front on a Model-T right now but I believe it's F4 to >> turn the echo on/off when you are in TERM >> >> Kurt >> >> On Mon, Jan 6, 2020, at 3:51 AM, James Zeun wrote: >> >> >> >> Hey guys >> >> I've finally had a chance to sit down with my M100 and try out my NASbox, >> however i think i must be doing something wrong. I mean it has been a while >> since i used this unit. >> >> So i went in to TELCOM, selected STATE and entered in 98N1DNN >> >> I then went TERM and tried to type in ACTIVATE, on i'm getting >> AACCTTIIVVAATEE >> UNKNOWN COMMAND >> >> What did this idiot do wrong? >> >> James >> -- >> My retro tech blog and general ramblings >> http://bytemyvdu.wordpress.com/ >> >> >> >
