Isn't the SR also included in the Rexx known compatible ROMs zip? Dec 19, 2020 6:51:52 PM Steve Baker <[email protected]>:
>>>> Lastly, has this ROM been dumped? If not, I’ll pull it off the PCB and >>>> read it. >>>> > > Hello again — I posted my chip to the club100 website earlier today, if that > helps > > http://www.club100.org/memfiles/index.php?&direction=0&order=&directory=Steve%20Baker > > Thanks, > SB > > -- > Greetings from Steve Baker > “Gravity brings me down...” > > >> On Dec 19, 2020, at 8:24 PM, Jeffrey Birt <[email protected]> wrote: >> >> >> >> I’ll try the pic again as it seems the first one was too large. >> >> >> >> Jeff Birt >> >> >> >> From: M100 <[email protected]> On Behalf Of Steve Baker >> Sent: Saturday, December 19, 2020 7:07 PM >> To: [email protected] >> Subject: Re: [M100] SuperROM >> >> >> >> Another pic, not sure it was attached correctly... >> >> >> -- >> >> Greetings from Steve Baker >> >> “Gravity brings me down...” >> >> >> >> >> >> >> >>> On Dec 19, 2020, at 8:00 PM, Greg Swallow <[email protected]> wrote: >>> >>> >>> No edge for me to grab and my eyes are not good enough to line it up. >>> Maybe the attached photos can help. >>> >>> >>> <10081.jpg> >>> >>> >>> >>> >>> >>> Dec 19, 2020 5:47:48 PM Jeffrey Birt <[email protected]>: >>> >>>> SuperROM – >>>> >>>> >>>> >>>> Working on an M100 now that came with a SuperROM that had stuck in the >>>> socket and the socket managed getting it out. Socket replaced, but I am >>>> confused as to how the SuperROM (SR) was ever intended to fit properly. >>>> >>>> >>>> >>>> The SR gets stuck as while the Pin1/28 side is held up from the bottom of >>>> the socket by the pin 1 tab on the SR PCB, the opposite end drops down so >>>> far that the PCB falls below the bend of the contacts. This lets the >>>> contacts spring out over the top of the PCB and thus it is stuck. >>>> >>>> >>>> >>>> If I shim up the SR enough to prevent it getting stuck then it pops out >>>> very easily. It seems to be a very poor design. Perhaps there is some part >>>> of this one that is missing? I could not find any images on the web that >>>> clearly showed the SR board to compare to though. >>>> >>>> >>>> >>>> The contact is also really poor, sometimes it will make contact in the >>>> socket and sometimes not. It may be that the PCB was damaged when it was >>>> wrestled out. >>>> >>>> >>>> >>>> Lastly, has this ROM been dumped? If not, I’ll pull it off the PCB and >>>> read it. >>>> >>>> >>>> >>>> Thanks, >>>> >>>> Jeff Birt >>>> >> <IMG_9318_sm.jpg>
