Hi All,
Fairly new here but have been enjoying the discussion and learning a lot. I am fixing a Disc/Video interface for use with my model 100. I've got everything working fine now except I have to reach in and give the spindle motor on the floppy disc drive a "push" from underneath with my finger in order to get it started. Once it's spinning it's fine and everything loads, but any time the motor stops (like after it reads a disc), I have to do the same thing over again, which is of course not very convenient. I'm assuming this is a standard drive among Tandy equipment. Curious if anyone who has a similar FDD has run into the same issue or has any advice. Thanks much, James Copeland
