OK, good progress. I think the next step is to not use CNTL-X but use F7 from REXMGR. That will completely remove REXMGR altogether.
you could also try CLEAR0,MAXRAM before you start UR-2 On Mon, Nov 29, 2021 at 8:42 AM Patrick McDougal <[email protected]> wrote: > It is REX#2.1. I performed the following… > > 1. Removed the batteries and turned off the memory power. > 2. Restarted the machine and then performed a call 63012 > 3. REXMGR appears in the menu and then CTRL-X and removed the hooks. > 4. Opened BASIC, call 63012. > 5. Entered UR and selected View80. > > On the initial try, I received a continuous tone that required the reset > button. On the second try, I selected View80 and noticed “Can’t” displayed > below the menu. On the 3rd try, I received a “Change HIMEM?” and typed Y > and then attempted to enter the edit portion of T-Word and it locked up. > > Through my testing, I have also had the Telcom prompt pop up below the UR > menu when turning on View80. Oddly, I have never seen the option to select > the screen width that is mentioned in the UR documentation. > > I have reloaded the UR bx file in case of an error when transferring. For > what its worth, the machine has been very stable with no issues using UR > except when attempting to active View80. > > Any additional recommendations would be much appreciated. > > Thanks, > > Patrick > > On Nov 29, 2021, at 8:12 AM, Stephen Adolph <[email protected]> wrote: > > I seem to recall fixing this. Can you confirm you are on release 2.1 > firmware for REX#? it may well be a conflict. As Ben said using CNTL-X > before you start the ROM using Call 63012 (don't start the rom from REX > Manager) gives you a REX# free try. > > > On Mon, Nov 29, 2021 at 3:15 AM Ben Wiley Sittler <[email protected]> > wrote: > >> Have you tried removing the REX# hooks before activating 80 column mode? >> I believe they are not compatible >> >> On Sun, Nov 28, 2021, 16:50 Patrick McDougal <[email protected]> wrote: >> >>> To the group, >>> >>> As you may recall, I recently bought a used M100 off of Ebay. I cleaned >>> it up and upgrade the RAM to 32k and installed a Rex# (Thank you Steve!). >>> I successfully connected in to a Windows 10 machine using Laddie Alpha and >>> loaded the UR2100 ROM. I have been trying to use the View 80 function >>> which seems to install in high memory when I select it. When I attempt to >>> use T-Word, the blank text editing screen appears with a smaller cursor in >>> the left upper corner and then locks up. This requires a cold reboot of >>> the machine (removing the batteries and turning off the memory backup >>> power) to restore any function. I can then reload the RexMgr and start >>> again. This error does not occur if I do not load the View80 component of >>> Ultimate ROM. >>> >>> Has anyone else experienced this issue or have an idea about >>> troubleshooting? >>> >>> Thanks, >>> >>> Patrick >> >> >
