check pin 25; I think if the input from the printer is low you will be unable to print and the laptop will "freeze". [image: image.png] btw Cedric, were you able to snap that PCB pic I was asking about? thanks! Steve
On Sat, Apr 30, 2022 at 6:15 AM Cedric Amand <[email protected]> wrote: > Hello everyone > > I just finished my IDC 26 to centronics cable trying to print from my M102 > I'm printing on a 1985 Brother HL1109 so that should be period accurate > > Nothing happens if I hit "print", the M102 freezes and I have to "reset". > > I read on some TRS80 related documentation that there are POKE locations > to set the baud rate of centronics > Does that applyto the M100/M102 ? > What are the defaults ? Where are those POKEs and settings if any ? > I loked at the manual but apart from "hit PRINT" there isn't much info > > thanks ! >
