I have been using a seral Wi-Fi modem with my Model 102 without much fuss for the past few days. I switched it over to the Model 200 and no matter what I did I could not get it to work. I searched the boards and found plenty of discussion on flow control on the WiFI232 modem. While I don't understand it completely, the Model100/102 does not require it while the Model 200 does. The Wifi232 has solderable jumpers to fix this issue. The board I'm using does not have this, so I was considering jumping pins on the DB9 side of the device, however I'm not completely sure what I'm supposed to JUMP. I don't know if all that made much sense. Hopefully, someone can decipher what am asking.
Any Help would be appreciated, Joe
