First thing verify the connection to all the pins in the socket. It's a
common weak point. No weak/compressed pins, no oxidization, rex# fully
seated etc.
Otherwise what Steve said, run the install/update tool to reflash the Rex#.
--
bkw
On 5/25/23 21:27, Charlie Hoey wrote:
Hello there!
I had my first crash on a Rex# that I can't get myself out of, curious
if anybody has any tips.
I was in the process of creating a clean bank for a new project, and it
failed somewhere near the end. I RESET and then ran `CALL 63012` to
reload REX, but now whenever I start REXMGR, it attempts to load/write
something and hangs. I've done a cold reset, pulled batteries etc, so I
think it's in eeprom/flash somewhere. Here's a shot of what I'm seeing:
Screen Shot 2023-05-25 at 9.13.23 PM.jpg
If images don't work here, launching REXMGR shows the standard top line
with "REX #2.1" in the top left, and the bottom right is the progress
bar, which fills up most of the way and then hangs.
Any way I might peek/poke my way back to a usable state? I don't care
about the in progress job that failed, so if I could clear a flag or get
it to just abandon it that would be fine.
Thanks as always!
-Charlie
