I will try to open my M100 today so I can get you a photo, but before you close up - please replace the NICAD. Any Nicad that hasn't split corrosive goop all over the board is literally waiting till tomorrow, or next week to do so - It is not a case of it isn't going to happen, as one of it simply hasn't happened yet!
Even if you don't have a replacement - simply removing it is critical. Kindest regards, Doug Jackson em: [email protected] ph: 0414 986878 Follow my amateur radio adventures at vk1zdj.net On Thu, 31 Aug 2023 at 10:01, Peter Vollan <[email protected]> wrote: > Have you ever felt that you are better at taking things apart than at > reassembling them? I took apart my Model 100 to look into recapping it. > Then I read about replacing the three resistors, and, in fact, I have had > some serial port problems, although I don't really know that is the issue. > I have been flaking off on finishing the job for a while, being overwhelmed > by life, my apartment being an oven and so on. Yesterday I finally knuckled > down and installed the 330 ohm resistors. I decided to quit while I'm ahead > and not try to recap it, although the nicad measures 2.25 so I > might replace it. > > Could you tell me where these two pieces go? > >
