Is that connector for the battery light ? I also have numerous donor boards just need to be sure what I'm looking for.
Joe -----Original Message----- From: M100 <[email protected]> On Behalf Of Hiraghm Sent: Saturday, January 20, 2024 5:39 PM To: [email protected] Subject: [M100] Halp! Cut wire at connector in M100 Awhile back I'd taken on the task of recapping my two M100s. On one it worked great; on the other, it was "dead" afterwards. I suspected either a cap I didn't get properly soldered, or just flux I didn't clean off the board sufficiently. So today I opened it up again to take the motherboard out and see if I could get it working. I needed to disconnect a two-wire connector that sits just above the "CN8" silkscreening, and connects to the LCD circuit board... While trying to pull it out, my needlenose pliers slipped, and I accidentally cut the red wire right at where it goes into the two-wire connector. It's cut flush with the connector. I don't even know what this kind of connector is called. Can anyone tell me what it's called and where I might be able to order a new one? If nothing else, can someone suggest how I can pull the bit of wire out of the connector? If push comes to shove I can just solder the remaining wire to the pin w/o the connector. But I *really* don't want to do that.
