http://tandy.wiki/Model_T_Parallel_Cable
Just a straight-through ribbon cable with a standard female IDC 2x20 on
one end and an IDC CN36 on the other end, with the stripe on the pin-1
mark on each end.
On 7/12/26 20:01, [email protected] wrote:
Hi,
What is the PIN out for the printer cables? I have a bunch of cables
with Centronics connectors.
==============================================================================================
C U L8r, °|° Walt Perko °|° "Kids ... teach them the good
stuff, and they still learn the bad stuff on their own."
http://www.R2Pv1.com/ <http://www.r2pv1.com/> *RoboGuts™ Intelligent
content for 3D printing making S.T.E.A.M. education better, easier and
more affordable *
**
Experiments to learn how to use various Electronic Components,
Structured Computer Programming, Phonemes for Speech &Song in any
language, and Art.
"The World Needs a New Economic Model"
==============================================================================================
BillyBotAvatar-2centsStamp-c
Sent from the Cyber7
*From:*M100 <[email protected]> *On Behalf Of
*[email protected]
*Sent:* Sunday, July 12, 2026 4:57 PM
*To:* [email protected]
*Subject:* [M100] Ideal length for M100 printer cable?
Hi all,
I had someone ask about acquiring an M100 printer cable a few weeks ago
and was surprised how much they were going for on eBay. I have an
original cable which is 6' long, which is a bit too long, I think. I
picked up some Centroincs connectors and just made a 3' one which is
fine for sitting the M100 next to a CGP-115 or larger printer but
perhaps not for having the printer sitting away from the M100.
What do you think the ideal length is? 3', 4', 5', 6' or perhaps just
offer then in either 3' or 6'?
Jeff Birt
(Hey Birt!)
--
bkw
