Hi The problem seems that the checkpoint generated does not save relevant program state. The checkpoint memory section is also completely blank. As a result in this particular case when the program reaches a point where it does a check for the input file name - it draws a blank and exits.
On further looking - I find that the functional memory - which has an associated serialize functionality - is only instatiated in the Full System build. I am using the Stand Alone model - and would like to know how I could configure my memory sub-system so that a checkpoint retains the required memory data. Thanks Brinda On Mon, 12 Jun 2006, Brinda Ganesh wrote: > Hi > > I am using the Simple CPU in stand-alone mode with at least 2 processors. > I generated checkpoints as described in your tutorial ( > using the --Serialize.cycle command line flag). I find that when the > simulator is made to take the input using the checkpoints ( by adding the > command line flag --Root.checkpoint) the simulator runs for several cycles > before halting with the following message > Terminating simulation -- halt instruction encountered > > The benchmark when executed without a checkpoitn input does run past this > point. > > I was wondering if you could tell me what could be the problem and how I > would go about fixing it. > > Thanks > Brinda > > > > > _______________________________________________ > m5sim-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/m5sim-users > _______________________________________________ m5sim-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/m5sim-users
