Hi,
When I attempt to resume an ammp checkpoint for ALPHA_SE AtomicSimpleCPU
at location 59*100E6 instructions into the binary, I am able to run in
AtomicSimpleCPU, but if I switch to O3CPU, I am able to run 248,483
instructions when suddenly i get the "Exiting @ cycle ... because
simulate() limit reached" which is the normal simulator exit event. As I
set things up to exit at a particular instruction count of 100E6, I an
uncertain what could be causing this early exit. Any ideas? I looked at
a trace of "O3CPUAll" and it seemed fine. (Side note: this seems to be
happening with any ammp checkpoint I take, where as others appears to be
fine).
-Richard
_______________________________________________
m5-users mailing list
m5-users@m5sim.org
http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
