I think I have that figured out that's why I had to change the pin setting to analog out.
What I am not getting is the machinekit client end when I switch on the heater it go's no but not off... I haven't changed any code in the machinekit client so I am not sure how it and what its sending to the machinekit running on the BBB connected thought the router I have machinekit client running on windows and a android tablet. Thanks gary On Monday, November 14, 2016 at 1:50:25 PM UTC-5, gary wrote: > I have a BeBoPr++ and all is working fine, > > Building another printer and using a CRAMPS, > > I can't seem to figure out why I can not get the E0 to turn on, when I > load machinkit I get no errors, > The axis screen pops up, when I go to the mdi and enter m104 p100 I get no > errors but it doesn't > change the setting under the Extruder Temp 0.0 stays at 0.0 and the temp > slider bar never go's up. > > The board is powering up when I hit machine power lets go from red to > looks like center is orange and outer led's at yellow ish.. > > Any suggestions ? > > Thanks gary > > > > > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.