On 04/01/17 17:06, Jeff Pollard wrote:
Hi,
I think you are looking for what is described in section 1.11.7 here:
http://linuxcnc.org/docs/2.4/html/gui_axis.html
Or better still you could use our own docs, which we spent a lot of time
getting up together.
Especially as the Axis in Machinekit contains several enhancements,
including one which
specifically does this
http://www.machinekit.io/docs/gui/axis-machinekit-enhancements/#preview-disable
regards
Jeff
On Wednesday, January 4, 2017 at 8:50:15 AM UTC-8, Marco Negrini wrote:
Hi everyone,
i was looking in the ini file, and i was wondering if i can set
axis to do NOT check the gcode before running.
--
website: http://www.machinekit.io blog: http://blog.machinekit.io
github: https://github.com/machinekit
---
You received this message because you are subscribed to the Google
Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected]
<mailto:[email protected]>.
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
