As well, I would need a 2-nd encoder for MPG, this is the reason I have been using 4x7i76. Any another configuration would do the task as well where I can have hardware PWM generators? Needed: 2-3 steppers, 2 encoders (spindle and MPG), 1 PWM, 10-12 GPIO's.
Best regards, Alexey On Wednesday, 10 May 2017 09:03:41 UTC-7, Alexey Volkov wrote: > > Hello > > I am using DE0-Nano-SoC with DB25 board, with mesa SOCFPGA firmware > 7i76_7i76_7i76_7i76. > I do not have mesa 7i76 boards and connecting speppers, spindle control > and encoders directly to the DB25 adapter. > I successfully set up and run 3 stepper generators, 1 encoder on P2 of the > DB25. Works very well, I was able to run STEP/DIR up to 500kHz rate. > I also tried to add PWN generators, declaring them same way as for > steppers: "pwmgens=1", it goes thru, but I do not see them in HAL and if I > try to call for the pwm generator machinekit complains what the PIN does > not exist. > Just wondering: Was PWMGEN implemented at all in SOCFPGA and if it was how > to use one. > Do I have to use custom build firmware to be able to use "hardware" PWM > generators? > I was able to use software PWMGEN, but it is working very slow (~0.5-1kHz). > > Best regards, > Alexey > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
