Mine was working well, but without retraction. Retraction had way too much pre-charge and it wasn't linear with what I set retraction to. Rather than figure that out as I had some other minor annoyances, I opted to go for the latest and greatest and put my extra stuff into that. In prior iterations I had a microswitch on the head tied to estop. Not this one. Crash, bang, done.
On Thursday, September 14, 2017 at 7:43:02 AM UTC-4, Tom M wrote: > > Oh boy.. see you around the next event. (Did you take any damage from > Irma?) > I'm trying to get switched over to Charles probotix solution on my MPCNC. > I'm currently running gantrykins and I keep forgetting to switch between > world and joint when I'm homing. I wind up inadvertently racking the > gantries. I cracked some of 3d printed bearing blocks. Luckily weld > repairing them is fairly easy. > Switches are wired and installed I need to install terminals, and hook > into the cramps and redo the Hal and ini's. Yikes, I'm running out of time > here. > > > > On Sep 14, 2017 2:47 AM, "Daren Schwenke" <[email protected] > <javascript:>> wrote: > >> I'm at my other home in FL currently and crashed the head on the printer, >> destroying part of the head and splitting my ceramic bed. Nema23 and 9mm >> belts may have been a bad choice. >> >> Tried updating to use the new pythonic configs and it turns out in the >> current fdm module (without using the subdirectory to override it like in >> the Rostock config I borrowed from machinekoder) the delta_r or rod length >> is ignored. So 0,0,0 was below the bed. I slowly approached it, but the >> interface didn't register my stop command until it was too late... so I got >> to watch it slowly destroy my bed. :) >> My fault for removing the physical estop button for aesthetic reasons.. >> >> Prime is screwy due to Irma so parts wouldn't get here in time for me to >> fabricate them, and I can't find a suitable polished ceramic tile locally. >> So... I'm not going. >> >> On Sunday, September 10, 2017 at 9:35:37 PM UTC-4, Tom M wrote: >>> >>> >>> Hey Guy's, >>> >>> If anyone is going to be at the Milwaukee Maker Faire feel free to stop >>> by and say hi. >>> >>> https://milwaukee.makerfaire.com/maker/entry/275/ >>> >>> Daren Schewenke is going to be there as well. >>> https://milwaukee.makerfaire.com/maker/entry/277/ >>> >>> Tom >>> >> -- >> website: http://www.machinekit.io blog: http://blog.machinekit.io >> github: https://github.com/machinekit >> --- >> You received this message because you are subscribed to a topic in the >> Google Groups "Machinekit" group. >> To unsubscribe from this topic, visit >> https://groups.google.com/d/topic/machinekit/Z84ZyZTkfe4/unsubscribe. >> To unsubscribe from this group and all its topics, send an email to >> [email protected] <javascript:>. >> Visit this group at https://groups.google.com/group/machinekit. >> For more options, visit https://groups.google.com/d/optout. >> > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
