Hi all,
I have been trying to get machinekit up and running on my RPI3. As you
might guess out of this post. No succes yet :)
I have the latest rasbian, meaning stretch. debian 9
So i have been googling and reading. So i followed first following:
10K replied the topic: LinuxCNC on Debian Stretch
TIm-
LIke you, I installed Stretch. I then added the rt kernel. I put in
linuxcnc-uspace, but not from the buildbot. Here's what I did, in case it
helps.
sudo apt-get install dirmngr
sudo apt-key adv --keyserver hkp://keys.gnupg.net --recv-key 3cb9fd148f374fef
Required version of libboost-python is not in stretch repository. Temporarily
point to jessie
sudo nano /etc/apt/sources.list with nano to contain:
deb http://ftp.us.debian.org/debian jessie main
sudo apt-get update
sudo apt-get install linuxcnc-uspace
Now remove the pointer to jessie in sources.list
sudo apt-get update
I did this but only the nano contain part i didnt understand.so skipped this.
than i followed the machinekit for kernel jessie RPÏ2
and after i did the previous, i was able to do the first 2 steps. Kernel and
building it. I didn't get any errors.
But now how do i start Machinekit, cause strangely enough, i can not find
anything on my Pi?????
I find to start a program you run in terminal simply machinekit, but that
results in command not found.
So now i am lost. Hope someone can help out.
Regards,
Stephane
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
