To get Beagle GPIOs configured correctly at boot, is a custom overlay
the right way to go? I want a bunch of the PocketBeagle pins configured
as GPIO output low, but some of them start up in other modes with
unwanted signals.
I attempted an overlay config [1]. It may not be correct, but it at
least compiles. It's installed as shown at the top of the file by
putting it in `/lib/firmware` and adding
`dtb_overlay=/lib/firmware/pb_goldibox-00A0.dtbo` to `/boot/uEnv.txt`.
That doesn't seem to have any effect on the pins in question, however.
Hints appreciated!
John
[1]: https://github.com/zultron/goldibox/blob/master/pb_goldibox.dts
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
