Hi, My configuration was incorrect, the stepgen vel and accel were too low. Once I increased them per the recommendation, the problems went away.
Thank you, Scott On Tuesday, January 15, 2019 at 8:45:50 PM UTC-5, Scott Nortman wrote: > > I am running a Gcode file with axis, and I get occasional following errors > that cause the program to stop. What would cause this; I am using open > loop stepper motors? -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
