Greetings fellow Machinekit users, I am wondering if Machinekit has any method of remotely receiving gcode commands from another application, similar to MDI mode except code is not typed directly at the UI. I am not concerned about security or latency and the gcode instructions I intend to send over are very simple, just G00/G01 and an occasional M code. I have found some unresolved posts asking a similar question however they are all several years old. Has such a capability been added on since then? Could someone point me in the best direction in which to implement such an option? I am open to developing a solution myself is necessary. Any advice would be greatly appreciated.
Thanks, Michael -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/machinekit/0a67eaea-755a-4cb1-87c9-d82789169d06o%40googlegroups.com.
