On Jun 3, 2009, at 16:26, Scott Haneda wrote:
On Jun 3, 2009, at 2:15 PM, Ryan Schmidt wrote:
The only reasons I can see for the message not showing up are 1)
the file ${prefix}/var/ASSP/assp.cfg exists, or 2) you are using
direct mode instead of image mode and therefore there is no
activate phase.
If you look up on the past email a little, I did this:
ASSP installs to var
$ls -la /opt/local/var/
total 0
drwxr-xr-x 3 root admin 102 Apr 3 01:34 db
drwxr-xr-x 11 root admin 374 Jun 2 19:59 macports
drwxr-xr-x 3 root admin 102 Apr 3 01:34 run
So not only does assp.cfg not exist, the entire parent directory is
not there either.
Ah yes, so it is.
I do not understand direct versus image mode, I will look to the
docs and see what I can get.
The short of it is to check your /opt/local/etc/macports/macports.conf.
If it says
portinstalltype image
it should be fine. If it says
portinstalltype direct
that could explain the activation phase being skipped.
_______________________________________________
macports-dev mailing list
[email protected]
http://lists.macosforge.org/mailman/listinfo.cgi/macports-dev
