On Sep 12, 2009, at 17:38, Ryan Schmidt wrote:
On Sep 12, 2009, at 17:33, Jack Howarth wrote:
Is there a general conf setting I can change
so that port output is always verbose during the
build (or just a specific phase)? It is nice that
port spews out the compilation when a compile time
error is hit but while working up packaging I would
like to see the actual build in detail.
There's no conf setting; you must use the "-d" switch every time.
sudo port -d install something
Due to the volume of information printed by the -d switch, its use can
cause you to overlook important messages ports sometimes print out.
For developing your own portfiles using -d is great and helpful, but
for general use, I recommend you install and upgrade ports without the
-d flag, and if you encounter an error, then clean the affected port
and try again with -d to see the full error.
_______________________________________________
macports-dev mailing list
[email protected]
http://lists.macosforge.org/mailman/listinfo.cgi/macports-dev
