On Feb 27, 2009, at 17:54, Scott Haneda wrote:
Stumped entirely, if I run a clean --dist, I will get a checksum
mismatch with the port name set to ASSP, if I run the port name set
to assp, I do not.
name assp
version 1.4.3.1
categories mail
maintainers hostwizard.com:scott
description Anti-Spam SMTP Proxy (ASSP) Server
long_description tba
homepage http://assp.sourceforge.net/
platforms darwin
master_sites sourceforge
use_zip yes
checksums md5 95191c8a081601a5b80557ad606d867a \
sha1
67d9587d78e8c6d2696ff13d5ae323bb513421f1 \
rmd160
0e0cc34e56a3d54e06f4d6a3c123322431d33dcc
depends_run bin:perl:perl5.8
distname ASSP_${version}-Install
worksrcdir ${distname}/ASSP
set assp_base ${prefix}/var/ASSP
# This distribution is just perl files
use_configure no
Yes, because with the port name set to "ASSP" it is trying to
download from "http://downloads.sourceforge.net/ASSP"; which doesn't
exist. "http://downloads.sourceforge.net/assp"; is where you need to
download from, hence you need to either name the port "assp" or set
the master_sites to "sourceforge:assp". "master_sites sourceforge" is
equivalent to "master_sites sourceforge:${name}"
Some side questions, I know about `port contents`, is there a
command to tell me the base in which the install has happened in,
other than looking through `port contents`? I want to cd `port
something` and get right to where the installed files are.
Most ports install all over ${prefix} so there is no command for that.
Maybe it is that I am just testing a lot, but a `port uninstall
ASSP` does not remove the files in /opt/local/var/ASSP, at least,
not all the time, What is the best way to get the distfiles, work,
and installed files gone, as well as unregister them?
"port uninstall ASSP" should always uninstall all files registered to
your port. If it doesn't, then the files were not registered to the
port.
I assume the portfile you posted above is incomplete because it
doesn't work for me; it says "make: *** No rule to make target
`all'. Stop." So I can't test this issue for you.
No matter what the name is, I can `port install assp` or `port
install ASSP`, so case is not mattering in the command phase, is
this normal? This is probably an OS X thing being case i?
Yes, this is normal. As far as I know, MacPorts takes care of this on
all operating systems so it's not Mac OS X-specific.
_______________________________________________
macports-users mailing list
[email protected]
http://lists.macosforge.org/mailman/listinfo.cgi/macports-users
