Em 04/06/2014, à(s) 23:51, Jason Swails <[email protected]> escreveu:
> > > > On Wed, Jun 4, 2014 at 10:15 PM, Gustavo Seabra <[email protected]> > wrote: > Hi Guys, > I’m trying to install gnucash by following the instructions here: > > http://wiki.gnucash.org/wiki/MacOSX/MacPortsDetail > > According to them, it gnucash needs to use xquartz, so that’s what I’m using. > > However, after a long, long time, the installation stops with the message > below. Isn’t it possible to install gnucash with xquartz anymore? > > It looks like not all of the variants are getting set appropriately in the > dependencies (either that or some of the dependencies were already installed > without the proper variants). If I had to guess, I would say it's probably a > subtle error with some of the MacPorts dependency trees. > > You can try rebuilding libcanberra with the +x11 variant and then try gnucash > again. This is the approach I've used in the past when I've gotten similar > errors. It sometimes takes a bit of prodding (basically doing this over and > over for all unsatisfied dependencies until it works). > > All the best, > Jason > > -- > Jason M. Swails > BioMaPS, > Rutgers University > Postdoctoral Researcher Hi Jason, I’m actually trying to build a non-x11, “native” osx build, so building with +x11 might not be the best way to go here. But I’ll keep that in mind in case it’s really needed. Thanks! Gustavo Seabra _______________________________________________ macports-users mailing list [email protected] https://lists.macosforge.org/mailman/listinfo/macports-users
