Try this first: port echo active and variant:quartz and variant:x11 \ | sed -n -e '/\+quartz/d;s/@[^+-]*//;s/\+x11/-x11+quartz/p' \ | xargs -n 2
If it looks reasonable (each output line should be <port> <variants> with no portion of the version string before the variant selections; could happen if a version includes a dash or plus), then running this (below) should do it. (Otherwise, just do it manually; likely not too many.) port echo active and variant:quartz and variant:x11 \ | sed -n -e '/\+quartz/d;s/@[^+-]*//;s/\+x11/-x11+quartz/p' \ | sudo xargs -n 2 port install Good luck! - Eric On Wed, Nov 18, 2015 at 3:29 PM, Bachsau <w...@bachsau.name <javascript:;>> wrote: > Eric A. Borisch wrote on 18.11.2015 15:43: >> >> You are using upgrade; what does 'port active and gtk3' show? +x11 >> perhaps? >> >> From the man page: >> >> By selecting the variants to use in the upgraded build of the >> port, any variants specified on the command line take highest >> precedence, then the variants active in the latest installed >> version of the port, and finally the global variants specified >> in variants.conf, if any. >> >> (Try adding -x11 to your upgrade line if the port active command above >> shows +x11.) > > > Yes, it shows +11. I added this my variants.conf after first install of > gtk3. Is there a way to find all ports still installed with +x11 and > reinstall with quartz instead? >
_______________________________________________ macports-users mailing list macports-users@lists.macosforge.org https://lists.macosforge.org/mailman/listinfo/macports-users
