#290: Rate control when sending raw frames in monitor mode
---------------------------------+------------------------------------------
Reporter: [EMAIL PROTECTED] | Owner: mrenzmann
Type: enhancement | Status: closed
Priority: trivial | Milestone:
Component: madwifi: other | Version: trunk
Resolution: wontfix | Keywords: monitor rate speed
Patch_attached: 1 |
---------------------------------+------------------------------------------
Changes (by jbicket):
* resolution: => wontfix
* status: reopened => closed
Comment:
anonymous may be correct that other drivers do not work the same was as
madwifi but that does not mean that madwifi should.
It needs to be more clear what this bug is, I guess it could be either:
- if there is a static bit-rate configured for a device, the monitor
device should use it when it sends packets (this is reasonable)
- rate control should run on the packets sent via the monitor device (this
is more difficult)
it's hard to understand why you would want to set the bit-rate for packet
injection unless you want the device to run a bit-rate selection algorithm
for you.
--
Ticket URL: <http://madwifi.org/ticket/290>
MadWifi <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
