#1192: Hardware Support: AR5007EG
-----------------------------------------------------+----------------------
      Reporter:  Jeremy Jackson <[EMAIL PROTECTED]>  |       Owner:       
          Type:  enhancement                         |      Status:  new  
      Priority:  minor                               |   Milestone:       
     Component:  madwifi: HAL                        |     Version:  trunk
    Resolution:                                      |    Keywords:       
Patch_attached:  0                                   |  
-----------------------------------------------------+----------------------
Comment (by fux):

 Hi.

 I have a "TP-Link WN310G Cardbus Card" here and have no luck to make it
 work with the patches from this trac entry.

 {{{
 MadWifi: unable to attach hardware: 'No hardware present or device not yet
 supported' (HAL status 1)
 }}}
 My output from ath_info:
 {{{
  -==Device Information==-
 MAC Version:  2425  (0xf0)
 MAC Revision: 2425  (0xf0)
 PHY Revision: 5110  (0x00)
  -==EEPROM Information==-
 EEPROM Version:     5.3
 EEPROM Size:        16K
 Regulatory Domain:  0x809C
  -==== Capabilities ====-
 |  802.11a Support: no   |
 |  802.11b Support: no   |
 |  802.11g Support: yes  |
 |  RFKill  Support: no   |
 |  32KHz   Crystal: no   |
  ========================
 GPIO registers: CR 00000000 DO 00000000 DI 00000014
 }}}
 lspci -vvnn:
 {{{
 03:00.0 Ethernet controller [0200]: Atheros Communications Inc. Device
 [168c:001d] (rev 01)
         Subsystem: Atheros Communications Inc. Device [168c:1055]
         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
 ParErr- Stepping- SERR- FastB2B- DisINTx+
         Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
 <TAbort- <MAbort- >SERR- <PERR- INTx-
         Latency: 0 (2500ns min, 7000ns max), Cache Line Size: 64 bytes
         Interrupt: pin A routed to IRQ 11
         Region 0: Memory at 90000000 (32-bit, non-prefetchable) [size=64K]
         Capabilities: [44] Power Management version 2
                 Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
 PME(D0-,D1-,D2-,D3hot-,D3cold-)
                 Status: D0 PME-Enable- DSel=0 DScale=2 PME-
 }}}
 Any hints? Thanks in advance.

-- 
Ticket URL: <http://madwifi.org/ticket/1192#comment:220>
madwifi.org <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Madwifi-tickets mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-tickets

Reply via email to