#2140: Packet's don't go out under high load
-------------------------------------+--------------------------------------
 Reporter:  [EMAIL PROTECTED]    |             Type:  defect  
   Status:  new                      |         Priority:  major   
Component:  madwifi: driver          |          Version:  v0.9.3.2
 Keywords:  outgoing packets freeze  |   Patch_attached:  0       
  Pending:  0                        |  
-------------------------------------+--------------------------------------
 Hello,

 I am using madwifi-0.9.3.2 in adhoc mode. Under high load (ie when there
 is a lot of ongoing traffic), I experience the following problem:

 Although tc -s qdisc dev show wifi0 shows that many KB's of packets are
 backlogged, and my UDP socket queues are also full. I can't see any
 outgoing packets. I verify this problem by

 a) doing a tcpdump -i ath0 "ip src 100.0.0.X" on the offending node (whose
 IP is 100.0.0.X), and on some neighboring node (that can hear X). I see
 nothing going out.

 This happens erratically, ie it may or may not happen all the time. This
 makes it all the more perplexing. I have a twenty node testbed, and it
 seems to happen randomly on any one of them.

 And sometimes, this only happens if I am sending Non best effort packets
 out. Like by doing ping -Q 0x08 (or even with the voice queue 0x30 etc).
 But sometimes, this affects all outgoing packets, even best effort ones.

 The problem disappears after a long time on its own, of the order of half
 to a couple of hours.

 Here is my relevant system info: (Ubuntu 7.10 on an intel mac mini)

 lspci -vv:

 02:00.0 Ethernet controller: Atheros Communications, Inc. Unknown device
 001c (rev 01)
         Subsystem: Apple Computer Inc. Unknown device 0086
         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
 ParErr- Stepping- SERR- FastB2B-
         Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
 <TAbort- <MAbort- >SERR- <PERR-
         Latency: 0, Cache Line Size: 256 bytes
         Interrupt: pin A routed to IRQ 16
         Region 0: Memory at 90100000 (64-bit, non-prefetchable) [size=64K]
         Capabilities: [40] Power Management version 2
                 Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
 PME(D0-,D1-,D2-,D3hot-,D3cold-)
                 Status: D0 PME-Enable- DSel=0 DScale=0 PME-
         Capabilities: [50] Message Signalled Interrupts: Mask- 64bit-
 Queue=0/0 Enable-
                 Address: 00000000  Data: 0000
         Capabilities: [60] Express Legacy Endpoint IRQ 0
                 Device: Supported: MaxPayload 128 bytes, PhantFunc 0,
 ExtTag-
                 Device: Latency L0s <512ns, L1 <64us
                 Device: AtnBtn- AtnInd- PwrInd-
                 Device: Errors: Correctable- Non-Fatal- Fatal-
 Unsupported-
                 Device: RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
                 Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
                 Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s L1, Port
 0
                 Link: Latency L0s <512ns, L1 <64us
                 Link: ASPM Disabled RCB 128 bytes CommClk+ ExtSynch-
                 Link: Speed 2.5Gb/s, Width x1
         Capabilities: [90] MSI-X: Enable- Mask- TabSize=1
                 Vector table: BAR=0 offset=00000000
                 PBA: BAR=0 offset=00000000
         Capabilities: [100] Advanced Error Reporting
         Capabilities: [140] Virtual Channel

 iwconfig:

 ath0      IEEE 802.11b  ESSID:"XYZ"  Nickname:""
           Mode:Ad-Hoc  Frequency:2.437 GHz  Cell: Not-Associated
           Bit Rate=11 Mb/s   Tx-Power=15 dBm   Sensitivity=1/1
           Retry:off   RTS thr:off   Fragment thr:off
           Encryption key:XYZ   Security mode:restricted
           Power Management:off
           Link Quality=16/70  Signal level=-80 dBm  Noise level=-96 dBm
           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
           Tx excessive retries:0  Invalid misc:0   Missed beacon:0


 Are you folks aware of this problem ?. Has it been rectified in 0.9.4
 version ?. Or is it because I am doing something wrong. Thanks.

 I would be grateful for your advise.

-- 
Ticket URL: <http://madwifi.org/ticket/2140>
madwifi.org <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Madwifi-tickets mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-tickets

Reply via email to