On 08/30/2012 08:01 AM, Frank Griffin wrote:
On 08/30/2012 07:45 AM, Remco Rijnders wrote:
Courtesy of wobo, this is what we used last weekend:
- Add "init 3" to the boot parameters, this should take you to text
only login.
- Run XFDrake to see what driver you are using and possibly adjust it
if needed.
That will work fine, if you're lucky enough to have a driver/card that
works in text mode without firmware. Unfortunately, the older ATI
ones don't.
FWIW my laptop has an ATI Radeon Mobility 4250 and I do a fresh cauldron
install about every other week. I do have initial issues with the
Radeon upon first boot; however, I always just login to run level 3, (I
add "ro 3" not "init 3", but get the same result.) add the non-free
repo then install the needed drivers, firmware and fglrx kernel mod.
Reboot to RL3 again. Run the display setup program. Adjust settings
accordingly, then reboot to RL5 and proceed normally.
Regards
--
/"A mind that is stretched by a new experience can never go back
to its old dimensions."/
*~Oliver Wendell Holmes, Jr.*
