On 22 Mar 2013 22:21, "Glen Ogilvie" <[email protected]> wrote: > > On 23 March 2013 05:12, AL13N <[email protected]> wrote: >> >> Op vrijdag 22 maart 2013 07:38:56 schreef Frank Griffin: >> > On 03/22/2013 07:20 AM, Glen Ogilvie wrote: >> [...] >> > > 1. How does the src tar.xz file for drakx-installer-stage2 get >> > > created? I assume it comes from a >> > > build of svn://svn.mageia.org/svn/soft/drakx/trunk >> > > <http://svn.mageia.org/svn/soft/drakx/trunk>, but can't find how it >> > > ends up as a tar.xz >> > >> > I'm maybe about two days ahead of you on this, but here's what I think >> > happens, FWIW. You do your checkout, and then in the mdk-stage1 >> > subdirectory, do a "make dist-svn". This should produce the tar.xz in >> > the mdk-stage1 directory. >> [...] >> >> "make dist" actually... >> >> it will target make "dist-svn" or "make dist-git" depending on if you're using >> git-svn or not. >> >> be advised that dist-svn uses the BASE and any uncommitted change will not be >> applied. >> >> dist-git however, you can commit without pushing them and that will be used. >> > > I've had a good play around with make dist. > It seems to me, like running make dist in the perl-install directory, (svn://svn.mageia.org/svn/soft/drakx/trunk/ ) > does not produce the same tar.xz file as found within drakx-installer-stage2 sources. > For example, the tar.gz produced by "make dist" does not contain the "kernel", "perl-install/install" directories, etc. > Also, inside the tar, the first directory is: "drakxtools-15.29", rather than "drakx-installer-stage2-15.29". It is also > only 2.4MB instead of about 4.3MB. > > Any suggestions?
Yes, you need to go into install subdirectory (if I remember the name correctly)
