Team ImageMagick,
How do we use the Identify command in Imagemagick to find out dpi resolution for a TIFF File. Identify works for with Width and Height similarly does the unit type=dpi give me dpi results. identify -quiet -format "%w,%h" BASELINE_R_600.TIF Thanks and Regards -Yogesh Yogesh Kadam S| Test Lead| MindTree Consulting Ltd. |West Campus, Global Village, RVCE Post, Mysore Road, Bangalore-560 059, INDIA | Voice +91 80 26265512 Extn: 5512 / Fax +91 80 2671 4000 | Mob : 9844 56 46 86 | email: [EMAIL PROTECTED] |www.mindtree.com <mailto:[EMAIL PROTECTED]|www.mindtree.com> | DISCLAIMER: This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited. E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside. Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission. MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where. _______________________________________________ Magick-users mailing list [email protected] http://studio.imagemagick.org/mailman/listinfo/magick-users
