On Sat, 2002-11-30 at 11:36, Craig Isdahl wrote: > Hello Everyone, > > First off, my linux skills are in the learning stage so this may > be a very silly question. I'm trying to setup mailman and I > have installed apache-1.3.23-14, postfix-1.1.7-2, and > python-1.5.2-38. This is RH 7.3 and the installed python is the > single "python" selection from the RH installation disk. When I > tried to install mailman-2.0.13-6.i386.rpm I get: > > [root@lists root]# rpm -Uvh mailman-2.0.13-6.i386.rpm > error: failed dependencies: > crondaemon is needed by mailman-2.0.13-6 > python-modules is needed by mailman-2.0.13-6 > > So I checked the archives and it was suggested I needed to > install python-devel-1.5.2-38. I also installed the docs and > tools for the same version. I'm still receiving the same error > as above. > > Two obvious questions: > - what is meant by python-modules since I can't seem to find > them on searches? > > - I have the crondaemon installed and running, isn't it crond > below? If so why the error message?
I think the same discussion applies to both questions. Where did you get the RPM that you're using? I don't think you got it from Red Hat, because mailman-2.0.13-1.i386.rpm is the latest RPM for Red Hat Linux 7.3. In general, it's pretty important only to use RPMs designed for specific Linux distributions, unless you really know what you're doing. Please try the Red Hat rpm (the software inside is the same thing, Mailman 2.0.13) and you shouldn't get the same dependency problems. To find out information about an RPM's maker, etc., run "rpm -qip filename.rpm" . If you run that command on the Red Hat Linux mailman-2.0.13-1.i386.rpm, you'll see a bunch of EXTREMELY important setup notes -- things you must do after installing the RPM. Follow those instructions! Don't complain if you don't follow them and stuff doesn't work! *grin* Alternatively, you should consider using the "tar.gz" source version of mailman, available from any of the mailman distribution sites such as list.org, instead of an RPM. This is the version that's more widely used and supported more commonly on this mailing list. But I do understand the many advantages of installing all software via RPM. --Jeremy ------------------------------------------------------ Mailman-Users mailing list [EMAIL PROTECTED] http://mail.python.org/mailman/listinfo/mailman-users Mailman FAQ: http://www.python.org/cgi-bin/faqw-mm.py Searchable Archives: http://www.mail-archive.com/mailman-users%40python.org/ This message was sent to: archive@jab.org Unsubscribe or change your options at http://mail.python.org/mailman/options/mailman-users/archive%40jab.org
