Hello,
Thank you for your reply. I have reproduced the issue in firefox also, but I
get no error message in firebug, only the alert with the message "Problem:
The application encountered a problem and could not finish the operation you
just requested properly."
With DWF viewer all works ok (the point can be selected) but with Ajax when I
select a point, I get an alert with all the values /properties from the
non-spatial table. After I press OK, i get the properties of the point in the
"Properties" frame but the point is still not selected (no error message in
firebug).
Thank you,
Iulia
________________________________
From: Zac Spitzer <[email protected]>
To: Iulia Tamas <[email protected]>; MapGuide Users Mail List
<[email protected]>
Sent: Saturday, December 10, 2011 6:41 AM
Subject: Re: [mapguide-users] Unable to select a point using Fusion viewer
can you try it in firefox with firebug and see if you can see any
further error messages? the embedded IE in studio makes
debugging very hard
On Sat, Dec 10, 2011 at 1:23 AM, Iulia Tamas <[email protected]> wrote:
> Hello,
>
> Message is displayed when selecting a point on the Map using Fusion viewer.
> The data is stored in non-spatial table in Oracle and a primary key is set
> on the table.
> Other layers that use a .sdf file as a data source can be selected.
> I'm using Mapguide 2.2 on 64 bit machine.
> I've attached an image with the received message.
> Has anybody encountered the same problem?
>
> Thank You,
> Iulia
>
>
> _______________________________________________
> mapguide-users mailing list
> [email protected]
> http://lists.osgeo.org/mailman/listinfo/mapguide-users
>
--
Zac Spitzer
Solution Architect / Director
Ennoble Consultancy Australia
http://www.ennoble.com.au
http://zacster.blogspot.com
+61 405 847 168
_______________________________________________
mapguide-users mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/mapguide-users
