Hi all,
I think I know the answer to this one already, but I have learned never to
pre-empt the knowledge of the list!
Is it possible to pass command-line parameters to an MBX? e.g. "Run Application
Myapp.MBX 1 Hello 3.5"
As a bit of a dabble I tried "parameterising" the Main sub:
declare sub Main(byval param1as Integer)
... but MapBasic didn't fall for it.
Any thoughts gratefully received.
Cheers,
David Jerrard.
*************************************************************
Opinions contained in this e-mail do not necessarily reflect
the opinions of the Queensland Department of Main Roads, or
of Queensland Transport. If you have received this electronic
mail message in error, please immediately notify the sender
and delete the message from your computer.
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
