When using ArcLink to create an ArcInfo e00 I get this error:
WARNING: EBADSEG:
Can't build topology.
Possible bad polygon in table e:\bradat\bldout.tab.
Polygon may have figure 8 or other abnormality
Polygon is in row# 312 or row# 315 or near point (-71.044062,42.371662)
Each time I delete one these rows the AcrLink will run a little further
before dying. How can I find all of these at once and get rid of them. Some
do seem to be figure 8 but many are other abnormalities.
I am new to MapInfo an am not sure of all the things that could go wrong or
what other abnormalities could mean. In some case it seems to just be a copy
of the polygon on top of an existing polygon. How can I find all of these?
Any ideas would be helpful.
Mike
[EMAIL PROTECTED]
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
