We have installed a HP JetDirect network printer port on our NT network.
Its one of those little thingys that gives you 3 printer ports on your
network referenced by an IP{ address, without having to have a whole
computer dedicated to the simple act of printing.
Whenever we print to our CadJet printer on this port, we only get an A4
page printed. If we connect the printer to LPT1 and set the port
appropriately, the printer works fine (no change to the printer drivers).
I seem to remember that there was a network setting that we should
investigate to remedy this. Any pointers?
Robert Crossley
Trinity Software
10 Trinity Street
Parramatta Park
CAIRNS 4870
AUSTRALIA
Phone: 61-7-40314877
Fax: 61-7-40314810
email: [EMAIL PROTECTED]
web: www.trinitysoftware.com.au
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
