Hi All!
When digitizing adjacent features, use the tracing ability of MapInfo.
Here's how to trace the nodes of an existing polyline or polygon:
1. Press the �S� key to activate Snap Mode.
2. Click on a node of the polyline/polygon you want to trace.
3. Move the mouse to another node of the same object.
Polyline: hold down the Shift key or the Ctrl key and click.
Polygon: hold down the Shift key for the shorter set of nodes or the
Ctrl key for the longer set of nodes and click.
Pressing the Shift or Control keys highlights the trace path. Click to
automatically trace the segments between the nodes and add them to the
polyline/polygon you are drawing.
Note: you can only trace one object at a time. There must be nodes where
you want to start and end the tracing, so you must consider adding nodes
if a perfect fit is necessary.
Hope this helps
Mats.E
--
:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
:Email/ [EMAIL PROTECTED] ICQ#9517386 :
:---------------------------------------------------------------------:
:Mail/ GISKRAFT, Mats Elfstroem, Vaepplingv 21, SE-227 38 LUND, SWEDEN:
:Phones: +46 46 145959, +46 70 595 3935 :
:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
