Phil,
Try "Connect the dots" which should be under the Tools section on the
http://www.directionsmag.com site
Cheers
Chris
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Saturday, 24 June 2000 6:52
To: Goodwin, Phil
Cc: [EMAIL PROTECTED]
Subject: Re: MI Automatic Line Drawing
>I would like to create a file with from-to latitude/longitude points and
>then have MapInfo draw lines between the dots. Is there a simple way to
do
>this? I have MapBasic but have little experience with it.
Update your_table Set Obj = CreateLine(from_lon, from_lat, to_lon, to_lat)
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
**********************************************************************
This message and any files transmitted with it are intended only for
the addressee. This message may contain confidential or privileged
information. If you are not the addressee of this message you must not
read, copy, distribute this information or take an action in reliance on it.
If you have received this message in error you are requested to
immediately contact the sender or Parks Victoria at
[EMAIL PROTECTED] and delete the original and any copies
of this message and any files transmitted with it. The views expressed
in this message are those of the individual sender, except where the
sender has the authority and specifically states them to be the views
of Parks Victoria. Parks Victoria accepts no liability for any damage
caused in the transmission, receipt or opening of this message and any
files transmitted with it.
**********************************************************************
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
