I had the same problem. You are right it's because 6.0 writes the printer setup
info in the workspace. So what you have to do is first change the header to make
it 550 not 600 and then delete the printer setup info in the workspace "Set
Window FrontWindow() Printer etc...."
Dan
[EMAIL PROTECTED]
"Lederer, Andre" <[EMAIL PROTECTED]> on 07/06/2000 10:37:36 AM
To: [EMAIL PROTECTED]
cc: (bcc: Dan Page/HullOttawa/PCH/CA)
Subject: Opening MI 6.0 workspaces w Proviewer
Hi everyone,
I've got a wee bit of a problem that I hope someone could help me with. I
created a workspace using MI 6.0 but cannot open it with Proviewer 5.5. Is
this because 6.0 writes printer setup info to the workspace? Is there some
kind of a work-around. Should I re-install MI 5.5 on my machine into
another folder and use it for creating workspaces for proviewer???
Any help would be appreciated
Andre
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
