Another problem which probably has a simple solution that I haven't found
yet!
I have a Mapinfo layer that I want to use as a blank template layer - i.e.
the field names are defined but there is no data in the table.
In the Map Options dialog box I have set the Map Units to degrees, meters
and hectares and the Projection to Irish Transverse Mercator.
The problem arises when I close and reopen this table. When I now open the
Map Options dialog all of the values have reverted to defaults - degrees,
miles and square miles for the Map Units and Lat/Long for the Projection.
How can I prevent this from happening?
John O Donnell
_________________________________________________________
Local Government Computer Services Board Phone: +353-1-6097023
Phoenix House Fax:
+353-1-6097001
Conyngham Road email:
[EMAIL PROTECTED]
Dublin 8.
_______________________________________________________________
This message is intended only for the use of the person(s) ("the
intended recipient(s)") to whom it is addressed. It may contain
information which is privileged and confidential within the meaning of
applicable law. If you are not the intended recipient, please contact
the sender as soon as possible. The views expressed in this
communication may not necessarily be the views held by LGCSB (Local
Government Computer Services Board). Any attachments have been
checked by a virus scanner and appear to be clean.
Please ensure that you also scan all messages, as LGCSB does not
accept any liability for contamination or damage to your systems.
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
