I have saved copy as and changed the projection using that button . I then
load the new table and sure enough it comes up with the new coordinate
system. The problem is that at that point I go to update columns with the
Centroid command and it always brings up lats and longs. No matter what I
do as far as setting map coordinated through Map>options>projections)??
Gabor Vasarhelyi
Environmental Resources Management Australia (ERM) Pty Ltd
Ph. 9906 1666
Fax 9906 5375
________________________________________________________________________
________
While ERM has systems in place to encourage a virus free software
environment, unfortunately the same cannot be said of the large number of
organisations from which we receive electronically issued products. We
therefore recommend that files be checked prior to use. While you can
expect us to be careful, in view of the above factors, we cannot be liable
for any loss or damage, corruption or distortion of electronically trans
mitted information, or for any changes made to this information during
transferral or after receipt.
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
