Crystal reports is a separate program and not part of Mapinfo. Therefore
there are no Mapbasic command to run Crystal report.
The best you are likely to be able to do is 'Run Application' to run crystal
reports, and then possibly supply some command line
arguments.
If you buy the full CR package as opposed to the cut-down version supplied
with MI, you also get an ActiveX control that can be
used to run compiled reports directly from e.g. Visual Basic without going
through the CR package.
----- Original Message -----
From: Huang, Shu-Hua <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, September 07, 2000 5:20 PM
Subject: MI Crystal Report
> Hi all,
>
> Is it possible to automate Crystal Report through MapBasic codes? I can
> create the report manually. But don't have a clue about how to do it
> through MapBasic. Any suggestions?
>
> TIA
>
> ShuHua
> ----------------------------------------------------------------------
> To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
> "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
