Todd,
I've found this method to work for me.
Open your legend in a separate mapper. Size it until it shows what you
want. Frame the table as the legend in the layout window.
Hope that works for you as well.
-----Original Message-----
From: McNeil, Todd W. (TMCNEIL) [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, April 11, 2001 10:11 AM
To: '[EMAIL PROTECTED]'
Subject: MI-L MI: Legend in Layout Window
Hi all,
I have yet to figure out the Frame Tool that adds legends to your layouts.
I can adjust the Width, Height and the position of the legend, but cannot
see the whole legend. It gets cutoff, and if I create an image, the same
thing occurs. However, if I print the layout, the legend looks fine and
does not get cutoff. How can I adjust the legend frame correctly to get the
entire legend to show? Has anybody else noticed this?
Thanks,
Todd McNeil
GIS Specialist
Aeronautical Radio, Inc.
Annapolis, MD
Phone: 410-266-2302
Fax: 410-266-4010
E-mail: [EMAIL PROTECTED]
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.
_______________________________________________________________________
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, send e-mail to [EMAIL PROTECTED] and
put "unsubscribe MapInfo-L" in the message body.
