Yes, there is an advanced tab and the autorotate is checked. The whole map frame, borders, etc is within the 30x30 page size and under layout->options it shows only 1 page. It prints only one sheet, but it spits out an extra 14" of blank paper after the map. So instead of the 30x30 sheet with just the map, I end up with a 44x30 sheet that I have to trim 14" off from the bottom.
-Bob [EMAIL PROTECTED] writes: >Does the 650 print dialog have an "advanced" tab? >If so, you should be able to find an "auto rotate" button which should >help. >Other than that, you might try to zoom into your layout and make sure >that the >edges are away from the paper edges. I have notice my layouts, at times, >have >caused different peoples computers to spit out extra pages b/c my margins >are >set-up one way, and theirs another. On their computer, my layout that >was one >page, is no 2 or four. >I hope this helps >rm > >Robert DeRubeis wrote: > >> Hi there, >> >> I have a problem when printing from a layout in mapinfo 6.0. I am >using a >> HP650 plotter on win98. If I do a custom paper size and put in >something >> less than 36" width (like 30x30") it will print out the map fine, but >will >> also spit out extra paper, out to about 42". If I put the custom page >> size to 36" width (like 30x36), then it cuts it correctly without the >> excess paper out to 42". >> >> Has anyone else run into this? >> >> Bob DeRubeis >> GIS/Mapping >> 1-602-263-6811 >> X5454 >> >> --------------------------------------------------------------------- >> List hosting provided by Directions Magazine | www.directionsmag.com | >> To unsubscribe, e-mail: [EMAIL PROTECTED] >> For additional commands, e-mail: [EMAIL PROTECTED] >> Message number: 3901 --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 3909
