Hi list I am trying to automatically create a table showing the extent of individual aerial photographs, based on a point placed at the geographic location of the photos centre. Each point has photo scale and photo size, as an attribute, to calculate the ground distance and also a field for the flight-run bearing. I can easily use the "Create Rect" command to show the photo extent, but this is only applicable for flight runs that are exactly east-west or north-south. Unfortunately, in the real-world, flight runs are on an angle other than 0, 90,180 or 270.
The question is if I use the regions created by the "Create Rect" command, can I automatically rotate each individual object at a set angle, using the centroid for each object as the rotate point, or is there a better way? Any help would be appreciated. TIA Peter Dowdle Technical Officer (Asset Management) Ipswich City Council Ipswich, Queensland, Australia ********************************************************************** This e-mail contains information that is intended for use only by the addressee. If you have received this e-mail in error, you are advised that copying, distributing, disclosing or otherwise acting in reliance on this e-mail is expressly prohibited. Please advise the original sender by REPLY email that you have received this email in error. Thank you ********************************************************************** --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 4548
