I'm working with a lot of areas which are made from smaller areas which have been combined together. The small areas were originally digitised and are supposed to meet along common boundaries. Due to small errors in the digitisation, the combined areas contain small holes.
Is there a handy tool or method for removing these, leaving just the outer boundary of the combined areas? ===================================================================== This electronic communication and its attachments may contain confidential, proprietary and/or legally privileged information and are for the sole use of the intended recipient. If you are not the intended recipient, any use, distribution, or reproduction of this communication is strictly prohibited and may be unlawful; please contact the sender and delete this communication. MWH does not warrant or make any representation regarding this transmission whatsoever nor does it warrant that it is free from viruses or defects, correct or reliable. MWH is not liable for any loss or damage that occurs as a result of this communication entering your computer network. The views expressed in this message are not necessarily those of MWH. This communication cannot form a binding agreement unless that is the express intent of the parties and they are authorized to make such an agreement. MWH reserves all intellectual property rights contained in this transmission. MWH reserves the right to monitor any electronic communication sent or received by its employees. --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 7558
