David I think you'll probably have to look at the TAB file - when you adjust image styles new tags get written to it. EG switching an image to grayscale might write these tags in -
RasterStyle 3 1 RasterStyle 7 0 HTH Paul Crisp Syntegra Innovation Place Delta Bank Road Newcastle NE11 9DJ Tel 0191 461 4522 Fax 0191 460 1987 -----Original Message----- From: Eagle, David A [mailto:[EMAIL PROTECTED] Sent: 15 September 2003 11:24 To: [EMAIL PROTECTED] Subject: MI-L Raster Image Display Style Listers, I'm writing a short sub routine in MB7.0 to toggle the display of some raster mapping between the 'Original Image' style (colour) and 'Greyscale'. Does anyone know how to report the current display style because I don't want to try and alter a greyscale image to a greyscale image? TableInfo( ) will tell me whether the table is a raster or not and LayerInfo( ) gets me some of the way but neither give me a solution. Any pointers? Thank you, David This email and any attached files are confidential and copyright protected. If you are not the addressee, any dissemination of this communication is strictly prohibited. Unless otherwise expressly agreed in writing, nothing stated in this communication shall be legally binding. --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 8385 ******************************************************************** This email may contain information which is privileged or confidential. If you are not the intended recipient of this email, please notify the sender immediately and delete it without reading, copying, storing, forwarding or disclosing its contents to any other person Thank you Check us out at http://www.syntegra.com ********************************************************************
