Dear List, I am running a number of contours on 3 machines, 2 are NT and 1 is XP. (We managed to hide our 2 NT machines from ITU when they wanted to XP everything!) I have noticed a slight anomaly, which is becoming a little more than just an annoyance. I don't know if anyone has come across this. When running a contouring exercise on a fairly heavy grid, the XP machines tend to contour ok, but will not have the order of the contours correct on the map. This means that there are great blocks of the same contour. We then have to go through and cut out the contours above so that it sits at the right level. Has anyone else come across this, and is there a solution.
We are using VM ver 3 Regards Nick ++++++++++++++++++++++++++++++++++++++++++++ Nick Bean GIS Manager Information Solutions Group Black & Veatch Consulting Ltd e-mail: [EMAIL PROTECTED] Direct Line: + 44 (0) 1737 856 402 Fax: +44 (0) 1737 772 767 Black & Veatch Consulting Ltd is a part of the Black & Veatch Corporation Registered office: Grosvenor House, 69 London Road, Redhill, Surrey, RH1 1LQ, United Kingdom Registered no. 3681070 England This message has been sent via the Internet. Black & Veatch Ltd therefore can not guarantee that this message has not been modified in transit. This message on its own should not be viewed as contractually binding. This message and any files transmitted with it are confidential and intended solely for the use of the addressee. If you have received this message in error please notify the sender and destroy your copies of the message and any attached files. --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 10501
