All, I was wondering if anybody knew how to compile a mapbasic program without going through the mapbasic editor. I am aware that you can use mapbasic from a command line using either a -D or -L switch but this fires up the editor, compiles then closes. What I would like to do would be to invoke mapbasic compile without the editor appearing. Is anyone aware of how to do this?
The microOLAP mapbasic IDE appears to do this.....how? Regards, -------------------------------------------------------- Colin Henderson Pre and Post Sales Support Ordnance Survey Southampton, SO16 4GU Web: http://www.ordnancesurvey.co.uk Tel: ++44 (0)2380 792034 Mob: ++44 (0)7771 972307 --------------------------------------------------------- This email is only intended for the person to whom it is addressed and may contain confidential information. If you have received this email in error, please notify the sender and delete this email which must not be copied, distributed or disclosed to any other person. Unless stated otherwise, the contents of this email are personal to the writer and do not represent the official view of Ordnance Survey. Nor can any contract be formed on Ordnance Survey's behalf via email. We reserve the right to monitor emails and attachments without prior notice. Thank you for your cooperation. Ordnance Survey Romsey Road Southampton SO16 4GU Tel: 023 8079 2000 http://www.ordnancesurvey.co.uk --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 14030
