It appears that the Selection Tool requires the entire geometry of a record to be selected for it to be recognised, which presents a problem in circumstances such as where a user attempts to select one point that belongs to a record with a multiple point geometry type.
Are there any workarounds for this situation?
Many Thanks
Glen Carden
Informed
Solutions,
The Old Bank, Old Market
Place,
Altrincham, Cheshire, WA14 4PA, United
Kingdom
Tel: +44(0) 161 942 2000 Fax +44(0) 161
942 2015
http://www.informed.com
This email and any attachments are sent in confidence, subject to applicable legal privilege and upon the basis that the recipient will conduct appropriate virus checks. If you receive this e-mail in error please telephone us upon receipt on the above number. You are strictly prohibited from using, copying or disseminating it or any information contained in it, save to the intended recipient. You are also advised that the opinions contained within this e-mail are those of the author and may not be those of Informed Solutions, its associates or Clients. Internet communications are not secure and Informed Solutions Ltd is not responsible for their abuse by third parties, nor for any alteration or corruption in transmission, nor for any damage or loss caused by any virus or other defect.
--------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 16540
